If the port is not yet established, the port number is shown as an asterisk (*). The names that corresponds to the IP address and the port are shown unless the -n parameter is specified. The IP address and port number of the remote computer to which the socket is connected.
The name of the local computer that corresponds to the IP address and the name of the port is shown unless the -n parameter is specified. The IP address of the local computer and the port number being used. The netstat command provides statistics for the following: Parameter If this parameter is omitted, this command prints the selected information only once. Redisplays the selected information every interval seconds. This is equivalent to the route print command.
The -p parameter can be used to specify a set of protocols.ĭisplays the contents of the IP routing table. If the IPv6 protocol is installed, statistics are shown for the TCP over IPv6, UDP over IPv6, ICMPv6, and IPv6 protocols. By default, statistics are shown for the TCP, UDP, ICMP, and IP protocols. If this parameter is used with -s to display statistics by protocol, Protocol can be tcp, udp, icmp, ip, tcpv6, udpv6, icmpv6, or ipv6.ĭisplays statistics by protocol. Set firewall to open port 6666 meterpreter > shell C:\Windows\system32 > netsh firewall C:\Windows\system32 > netsh firewall show opmode C:\Windows\system32 > netsh firewall show portopening C:\Windows\system32 > netsh advfirewall firewall add rule name'netcat' dirin actionallow protocolTCP localport6666. In this case, the Protocol can be tcp, udp, tcpv6, or udpv6. Shows connections for the protocol specified by Protocol. This parameter can be combined with -a, -n, and -p.
You can find the application based on the PID on the Processes tab in Windows Task Manager. This parameter can be combined with -s.ĭisplays active TCP connections, however, addresses and port numbers are expressed numerically and no attempt is made to determine names.ĭisplays active TCP connections and includes the process ID (PID) for each connection.
Note that this option can be time-consuming and will fail unless you have sufficient permissions.ĭisplays Ethernet statistics, such as the number of bytes and packets sent and received. In this case the executable name is in at the bottom, on top is the component it called, and so forth until TCP/IP was reached. In some cases well-known executables host multiple independent components, and in these cases the sequence of components involved in creating the connection or listening port is displayed. Syntax netstat ĭisplays all active TCP connections and the TCP and UDP ports on which the computer is listening.ĭisplays the executable involved in creating each connection or listening port. This command is available only if the Internet Protocol (TCP/IP) protocol is installed as a component in the properties of a network adapter in Network Connections.